|
LIQUID PHASE FROM GAS PHASE SEPARATOR
TYPE: ODK-1 PN10 DN15-32
CLICK ON IMAGE TO ZOOM
1. Application range
Nominal pressure:
Body nominal pressure:
Body testing pressure:
Tightness testing at negative pressure:
Maximum operating temperature:
- To max: 165°C (periodically up to 200°C)
Maximum operating pressure:
Maximum back pressure:
2. Basic materials
Body, cover, float:
- acid resistant steel 00H18N10 (1.4306)
steel cover with E-CTFE ( commercial name is Halar) at the client's request
Elements of the needle mechanism:
- acid resistant steel 00H17N12M2 (1.4401)
3. Design
Connections:
- flanged DN15 - DN32, face type B1 acc. to PN-EN 1092-1
screwed Rp 1/2" - Rp 1 1/4"
butt weld ends S 1/2" - S 1 1/4"
flanges acc. to ANSI or DIN at the client's request
K2 socket can be made in two options (see fig. page 30)
4. Characteristics
Separators carry away liquid phase (condensate) at the operational temperature. They work in the following way: the mixture of liquid and gas flows in via the K1 socket to the cumulative chamber. Liquid accumulates at the bottom of the chamber. The level of the liquid rises and results in the lifting of the float. It causes the opening of the needle valve and condensate extraction via the K2 socket outside the separator. After the condensate level has been reduced the float drops and the needle valve closes.
Separators covered by E-CTFE are assigned to chemical, pharmaceutical and food industries. E-CTFE cover is very resistant to abrasion, concentrated nitric acid action, sulphuric acid action, aqua regia 50% action, sodium hydroxide solution action, petroleum action, petroleum derivatives action and ammonia.
The separators can work in extreme acid and alkaline conditions. They are resistant to these aggressive mediums because in their construction we have used acid resistant steel covered with Halar, also the elements of the needle lever mechanism are made of Titanium. In case of using aggressive mediums, during the dismantling of the device, you should pay attention to the small quantity of medium which could still be in the device. It is also advisable to use self protection equipment. The separator should be installed only in the vertical position (as shown on the drawing, according to the marked flow direction).
5. Requirements and testing
Flanges connecting sizes acc. to PN-EN 1092-1; (DIN; ANSI/ASTM).
Face to face acc. to the table.
Pressure testing acc. to PN-EN 12266, PN-EN 26948.
Certificate of conformity in acc. to PN-EN 10204.
Design acc. to WUDT-UC-WO-D.
Manufacturing acc. to WUDT-UC-WO-W.
Separators have been submitted for appraisal of conformity according to the Pressure Equipment Directive 97/23/EC.
6. Directions for ordering
When giving your order you should supply the following information:
- medium,
- the maximum operating pressure,
- the maximum operating temperature,
- type and size of the connections.
7. Additional information
- 24 months warranty compulsory acc. to the conditions which are in the manufacturer's warranty card.
- The manufacturer is able to undertake inspections and repairs of the fittings as well as replacement of the internal elements if required.
- All the requirements concerning the quality and technical specifications of the fittings should be taken into consideration in your order. With the fittings we provide specification sheets (technical and quality) as follows: standard - conformity declaration, Installation, Operation and Maintenance Manual, at the client's request - certificate 2.2 or 3.1.
We reserve the right to introduce some technical changes without notice.
|
